Mass Spectrometry - Supplies for the Thermo Finnigan 3200, OWA

The ALX6004 superfine aluminum oxide cleaning abrasive is the finest grit aluminum oxide abrasive.

The following alumina insulators are currently available for the Thermo instruments.

The following heater discs and cartridges are used to replace defective units in various diffusion pumps.

These 3/4" PTFE Ferrules are used to install Ion Gauge Tubes.

Ferrules, Jet Separators, and GC column.

These filaments are the same as our FF3200 and SF5100 filaments but they have a tungsten coil in place of the usual rhenium ribbon.

Rhenium Wire and Ribbon is used to manufacture filaments for mass spectrometers and ion gauges as well as medical applications.

Pyrex flared sample vials.

The following copper and gold plated copper gaskets are available for the vacuum flanges on Thermo/Finnigan mass spectrometers.

Copper wire ceramic insulated heater link wire.

This piece is made from high purity alumina ceramic.

Bayard-Alpert Design and Dual Tungsten or Burn-out Resistant Iridium

all types and sizes of O-Rings

Santovac 5P Ultra has the same properties of Santovac 5 but guarantees minimal amounts of the 3 and 4 ring polyphenyl ethers; less than .02% and .1% respectively and for ultra-clean applications such as mass spectrometry.

Mechanical Pump Oils for your vacuum rough pump needs.

Available in either pyrex glass or quartz.

Assembly for the Finnigan-MAT OWA/1020 mass spectrometer.

Thermocouple gauges measure pressure in terms of the amount of heat that gas will conduct away from a hot wire.

S.I.S. supplies the shut-off valve for Finnigan 3200, and 3300 mass spectrometers.