908-788-5550

Direct Probe Sample Vial Blocks

Direct Probe Sample Vial Blocks
Hover over image to zoom

Description

Sample Vial Block

Direct Probe Vial Blocks are used to hold sample vials and to evaporate samples prior to insertion into the mass spectrometer. The blocks are constructed of solid aluminum to hold heat. These sample vial blocks are custom machined in our machined shop. Each sample vial hole is stamped with a consecutive number to enable the accurate setup and retrieval of samples for analysis. Blocks can be placed on a hotplate or on top of your GC oven to evaporate the samples.

* Please state outside diameter (O.D.) and length of vials when ordering sample vial blocks.

Direct Probe Sample Vial Block, Height (in)=0.5
Part No. Width (in)Length (in)RowsColumnsTotal Cells Quantity
In Stock
Price
EA
Order
SVB1 0.754.021224 0*Lead time for this non-stock item is approximately 5 days. $80.00
Qty
SVB2 0.756.021836 0Standard lead-time for non-stock items is approximately two weeks depending on the item. $85.00
Qty
SVB3 1.04.031236 0Standard lead-time for non-stock items is approximately two weeks depending on the item. $85.00
Qty
SVB4 1.06.031854 0Lead time for this non-stock item is approximately 7 days. $95.00
Qty
Related Products
Popular Items also Purchased
  • Straight Pyrex Glass Sample Vials for Mass Spec ProbesStraight Pyrex Glass Sample Vials for Mass Spec Probes
    Straight pyrex sample vials.
  • Thermo Direct Probe Flared VialsThermo Direct Probe Flared Vials
    Thermo Direct Probe Flared Vials
  • Quartz Sample Vials for Mass Spec ProbesQuartz Sample Vials for Mass Spec Probes
    All vials are made to your specifications and are supplied in packages of ten, fifty and one hundred vials.
  • Direct Insertion Probe for HP MS with ControllerDirect Insertion Probe for HP MS with Controller
    A ½ inch probe inlet, provides the user with greater flexibility and much faster ramp rates than the standard HP DIP probe.
  • Cesium Iodide Calibration Compound (FAB-C2)Cesium Iodide Calibration Compound
    (FAB-C2)
    This is a 10% solution in distilled water and is used for the 2000 to 5000 range.
  • Waters/VG Autospec FilamentWaters/VG Autospec Filament
    VG and Vestec Mass Spec filaments by SIS - ribbon design.