Home
- ▶
- Heaters/Source
- ▶
- Agilent Heaters and SensorsMass Spectrometry, Scientific Supplies & ManufacturingScientific Instrument Services 5973 Source Heater Tamper Resistant Allen Wrench 5973/5975 Quad Sensor 5985 Source Heater Assembly Agilent Interface Heater Assembly 5971 Interface Heater
- ▶
- Filaments
- ▶
- Waters
- ▶
- 7070, Trio, Quattro (This Page)
Hover over image to zoom
Price: 135
Product ID : VGF1
VGF1 Coil Style=5 coil SIS VG7070 filament VGF2 Coil Style=3 coil SIS VG7070 filament
Description
SIS manufactures replacements for the VG 7070 filament which are similar in design to the original VG filament. This new design is a direct retrofit. Two styles are available: the standard five coil design (#VGF1), used on most instruments and the three coil design (#VGF2).
Replacement Coils (Part No. HC7) are also available from SIS.
VG/Waters/Fisons Filament Repair Your filaments are repaired and returned to you.
Wire Material for Scientific Applications A wide range of resistance type wires and precious metals for the repair and manufacture of filaments and heaters for mass spectrometers, SEM's and scientific instruments.
Heater Coils Standard size coils are used on several mass spectrometer heaters repaired by S.I.S.
VG Source and Thermospray Heaters Replacement heaters for VG mass specs.
Ceramic Washer Insulators A wide variety of alumina ceramic washers.
Ceramic Insulators for Fisons/VG Replacement insulators for your VG mass spec
Inland 45 Mechanical Pump Oil Inland 45 is the highest quality rough pump oil you can use for your mass spectrometer.
Micro-Mesh® Sheet Kits Micro-Mesh® Craftsman Kits
600 Grit Aluminum Oxide Cleaning Abrasive The ALX6004 superfine aluminum oxide cleaning abrasive is the finest grit aluminum oxide abrasive.
Purge and Trap Stainless Steel Purge Heads The top fitting of both purge heads consists of a 1/16" fitting for the attachment of the sparging needle followed by needle adaptor to seal the needle in place and provide for the attachment of the purging gas line.
Thermal Desorption Sample Loader This device is used to inject or load liquid samples directly into the S.I.S. Thermal Desorption Tubes, forcing the syringe contents onto the adsorbent resins in the desorption tube without any loss of sample due to back evaporation.
Short Path Thermal Desorption Accessories Supply Kit When ordering the Short Path Thermal Desorption System, a wide range of systems and accessories are available depending on the application requirements of the user.
Seals for SIS Thermal Desorption Tubes Seals are utilized in a variety of locations in the Short Path Thermal Desorption Unit.
Viton®, PTFE, and Silicone Sheets These sheets are particularly well suited for cutting your own gaskets and seals.
Needles for the Short Path Thermal Desorption System In the Short Path Thermal Desorption System, the needle serves as the transfer line for sample introduction into the Gas Chromatograph from the Glass Lined Thermal Desorption Tube containing the samples being analyzed.
Balston Exhaust Filters for Non-Hazardous/Non-Corrosive Applications Vacuum pump inlet and exhaust filters by Balston.