Micro-Mesh® Craft Kit

This kit is designed for use on plastic, acrylic, porcelain, fiberglass, solid surface, cultured marble. wood, decoupage, and more.  Perfect for pen makers, model makers and hobbyists.

---

FOR MODEL MAKERS AND HOBBIESTS

CONTENTS:

• 1 EACH: MICRO-MESH 2" X 2" SOFT TOUCH PAD
  • GRADE 1500 - COURSE
  • GRADE 1800
  • GRADE 2400
  • GRADE 3200
  • GRADE 3600
  • GRADE 4000
  • GRADE 6000
  • GRADE 8000
  • GRADE 12000- FINE
• 1 EACH: 5 3/4" X 5/8" HANDI-FILE: 100MX/150MX; 180MX/240MX; 400MX/600MX
• 1- 1OZ. BOTTLE MICRO-GLOSS LIQUID ABRASIVE
• 1- COTTON FLANNEL BUFFING CLOTH
  ------------------------------------------------------------------------------------------------------------

USES:
 

PLASTIC, ACRYLIC, PORCELAIN, WOOD FINISHES BURN INS, SOLID SURFACE, FIBERGLASS, DECOUPAGE, AND MORE:

Step 1 - Only Micro-Mesh as coarsely as needed to remove the original damage. If you can still see the original damage after using the first grade, repeat using a coarser grade. Only the scratch pattern left by the Micro-Mesh should remain. Sand using a straight line pattern. On the next Micro-Mesh step, change direction so you're sanding perpendicular to the previous pattern. This will help you with consistency. We encourage water be used for lubrication when possible.

Steps 2 - Progress up through the grits, going finer and finer until you match or reach the desired gloss level. If more gloss is required, apply a small amount of the MICRO-GLOSS after the Micro-Mesh 12000 step, using the flannel buffing cloth.

Rinse the used pads in water and set out to air dry, store for future use.

The handi-files can be used in hard to reach places, for removing parting lines, etc.